Powertrain Codes

Good

P0959

Auto Shift Manual Mode Circuit Intermittent

★★★ Common diagnostic code

P0959 means the vehicle detected a fault related to auto shift manual mode circuit intermittent. On most vehicles this points to the transmission, driveline, clutch, or control circuit that needs testing before parts are replaced.

Atlas Quality75% · Good
Editorial StatusGood
SeverityMedium
Can I keep driving?Use caution and diagnose before replacing parts.
Typical repair cost$100-$900
Typical labor0.5-2.5 hours

What P0959 Means

P0959 means the vehicle detected a fault related to auto shift manual mode circuit intermittent. On most vehicles this points to the transmission, driveline, clutch, or control circuit that needs testing before parts are replaced.

Before You Replace Anything

Record the evidence first. Clearing codes too early can erase the clues that point to the real fault.

✓ Save freeze-frame data✓ Check for additional trouble codes✓ Look for technical service bulletins✓ Verify battery voltage✓ Verify engine oil level and coolant level✓ Perform a visual inspection✓ Do not clear the codes yet

Common Symptoms

⚠ Check Engine Light⚠ Possible drivability issue⚠ Reduced performance⚠ Intermittent warning lights

Most Common Causes

Faulty related component90%
Damaged wiring or connector78%
Poor ground66%
Module communication issue54%
Mechanical fault42%

Diagnostic Confidence

Related sensor88%
Connector pigtail78%
Harness68%
Relay58%
Fuse48%

Use this as a starting point, not a replacement for testing.

Recommended Diagnostic Workflow

1Record freeze-frame data
2Inspect wiring and connectors
3Review live scan data
4Check power, ground, and signal circuits
5Perform manufacturer pinpoint testing
6Verify repair with a road test

Mechanic's Tips

Tip #1

Save freeze-frame data and check for related transmission, communication, voltage, and module codes. Always verify fluid level/condition and electrical integrity before condemning a sensor, solenoid, actuator, or module.

Common Mistakes to Avoid

✕ Replacing parts before testing power, ground, and signal circuits✕ Ignoring related codes and freeze-frame data✕ Skipping the visual inspection✕ Clearing codes before confirming the repair

Common Repairs

Repair wiring or connector damage

Success Rate: ★★★☆☆

Average Cost: $100-$900

Labor: 0.5-2.5 hours

Replace confirmed failed component

Success Rate: ★★★☆☆

Average Cost: $100-$900

Labor: 0.5-2.5 hours

Perform relearn or calibration if required

Success Rate: ★★★☆☆

Average Cost: $100-$900

Labor: 0.5-2.5 hours

Clear codes and complete a drive cycle

Success Rate: ★★★☆☆

Average Cost: $100-$900

Labor: 0.5-2.5 hours

Parts Commonly Replaced

Related sensorConnector pigtailHarnessRelayFuse

Tools Used During Diagnosis

OBD-II scan toolDigital multimeterBasic hand toolsManufacturer service information

Related Repairs

Diagnostic workflowComponent testingWiring inspectionRepair estimate checklist

How to Explain This to Your Customer

Your vehicle stored P0959, which points to a problem with auto shift manual mode circuit intermittent. The next step is diagnosis of the related circuit or component so the repair is based on test results instead of guessing.

Manufacturer Notes

Generic OBD-II information. Exact test steps, component names, connector locations, relearn procedures, and repair strategy may vary by make, model, year, transmission, and calibration.

Technician Notes

Save freeze-frame data and check for related transmission, communication, voltage, and module codes. Always verify fluid level/condition and electrical integrity before condemning a sensor, solenoid, actuator, or module.

Related Codes

P0700 P0715 P0720 P0730 P0740 P0750 P0755

FAQ

What does P0959 mean?

P0959 means the computer detected a fault related to auto shift manual mode circuit intermittent.

Is P0959 serious?

It can be. Transmission, clutch, or driveline faults can lead to limp mode, harsh shifting, no-start conditions, or additional damage if ignored.

Can I drive with P0959?

Avoid extended driving if the vehicle shifts poorly, slips, overheats, or enters limp mode. Diagnose it before continuing normal use.

Will P0959 fail emissions?

It may fail emissions if the Check Engine Light is on or readiness monitors are incomplete.

Project Atlas Feedback

Was this article helpful?

👎 Needs Improvement
Project Atlas Built by mechanics. Improved by mechanics.

Working on this repair?

Create a professional estimate in minutes.

✓ Email it to your customer✓ Track labor and parts✓ Convert it into an invoice✓ Keep a complete repair history
Start Free PistonCMS Account

Project Atlas

Chapter Status

Quality Score75%
Editorial StatusGood
Last ReviewedPending review
Template Version1.3.4

Editorial Readiness

Reference Chapter Checklist

○ Academy linked○ Quality Score ≥95✓ FAQ complete✓ Customer explanation✓ Internal links○ Reviewed

Why Trust This Guide?

✓ Updated regularly✓ Written for working technicians✓ Practical diagnostic process✓ Built for mobile mechanics and independent shops✓ Maintained by PistonCMS

Built by mechanics. Improved by mechanics.

This guide is maintained for working mechanics, mobile technicians, fleet maintenance professionals, and independent repair shops.